Pinnacle-systems DR Bedienungsanleitung PDF herunterladen (Seite 26)

Installation Procedures

DIN-rail Controller Module

Controller Module Setup

Internal jumpers inside the Controller Module allow for

selection of pylon length (height of tower itself). Table

6 demonstrates how to set the internal jumpers if you

wish to use the Controller Module with a set of pylons

that are a different length.

EXT Activates External Relay Checking function

(see Standard Features, “External Relay

Check”).

FLASH Increases immunity to weld ﬂ ash by slowing

down the curtain (doubles response time).

CLOSE Activates Latching Relay Reset feature (see

Standard Features, “Resettable Latching

Relays”).

AB/FLT Selects either Auto Blank or Floating Blank

(jumper = Auto Blank).

Figure 4: Internal Circuit Board View

Table 6: Internal Jumper Settings with Different Pylon Lengths

Installation Procedures

DIN-rail Controller Module

 4" 8" 12" 16" 20" 24" 28" 32" 36" 40" 44" 48" 52" 56" 60" 64"

L011111111

L1 11 11 11 11

L2 1111 1111

L3 11111111

L4 1111111111111111

 68" 72" 76" 80" 84" 88" 92" 96" 100" 104" 108" 112" 116" 120"

L01111111

L1 11 11 11 11

L2 1111 1111

L3 11111111

1 = Jumper

For pylons with 1” beam spacing, install the Jumper plug (just below L0)

For pylons with 1/2” beam spacing, remove the Jumper plug (just below L0)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Keine Kommentare

Pinnacle-systems DR Bedienungsanleitung Seite 26